Advertisement
Available languages
Available languages
Case 8 - How can I replace a wired connection between
a DSL modem and the computer with a wireless link?
Aside from the LAN Access Point, a Wireless LAN PC Card supporting
the IEEE 802.11g standard and/or a wireless LAN converter are required.
Case 9 - How do I use the Quick Setup switch?
The Quick Setup switch is used to configure the Access Point together
with the 2.4 GHz Wireless LAN Converter PCWA-DE30. For details, see
the Wireless LAN Converter PCWA-DE30 Quick Start Guide.
Case 10 - After pressing the Quick Setup switch, the Status
indicator starts flashing red
If the Quick Setup switch is held down for more than one second, the Status
indicator starts to flash red. 30 seconds later, the status indicator begins
flashing slowly to indicate normal operation (white).
The Quick Setup switch is used to set up the separately available
Wireless LAN Converter PCWA-DE30.
For more information on how to use the Quick Setup switch, refer to
the Wireless LAN Converter PCWA-DE30 Quick Start Guide.
Case 11 - I cannot connect with an IEEE 802.11b-compliant
Wireless LAN PC Card
Check whether the Access Point Connection Mode is set to 802.11g only.
You can change the Access Point Connection Mode with Advanced Setup.
When the 2.4 GHz Wireless LAN PC Card PCWA-C100 is used, do not set
the key length to WEP 128 Bit. Otherwise connection will not be possible.
Instead set the key length to WEP 64 Bit.
Case 12 - After updating the firmware, the Status
indicator's flashing pattern is strange
If the indicator flashes slowly white with occasional red flashes, the update
was not completed successfully. Perform the update again.*
* The white flashing pattern (9 seconds on, 1 second off) and the red flashing pattern
(2 seconds on, 8 seconds off) occur simultaneously.
11
Advertisement
