Advertisement
Available languages
Available languages
When the Access Point setup is complete, return the proxy setting to its
4
original condition.
Example 2 : Using Netscape
Start the web browser on the computer used for the Access Point setup.
1
On the Edit menu, click Preferences.
2
In Category, click Advanced and click the Proxies button.
3
Select Direct connection to the Internet and click OK.
4
When the Access Point setup is complete, return the proxy setting to its
5
original condition.
Case 4 - I do not know which Access Point to select
Verify the MAC address indicated on the label inside the back cover of the
Wireless Unit. In the Access Point list of the Access Point Scan Utility, select the
Access Point with the same MAC address.
Case 5 - I can no longer connect after the Access Point
settings had been changed
I forgot the Access Point settings
If you forgot the settings of the Access Point, reset the Access Point to its
factory defaults as described in Case 6 and then perform the setup again as
described in the Quick Start Guide.
The Network Name (SSID) or Encryption (WEP) key was changed
With Windows Me or Windows 2000, refer to the instruction manual provided
with the wireless LAN PC Card you are using and change the computer
settings so that they match the Access Point settings.
With Windows XP and the Wireless LAN PC Card, follow the procedure below
to change the computer settings:
Perform steps 1 and 2 of Case 2, section Is your computer properly
1
configured for wireless communication?
Click Advanced.
2
From Available Networks, select the same name that you set for
3
the Access Point Network Name (SSID) and click Configure.
If the network has the same name of one appearing in Preferred
networks, select the network from the list in Preferred networks
and click Remove to remove it from the list.
9
Advertisement
