Lindy 35403 User Manual page 5

User Manual
Product Diagram & Installation
35403
VGA In: Connect to a VGA source device.
Audio In: Connect to a an audio input devices.
VGA Out: Connect to a local VGA display.
Audio Out: Connect to a local audio output device using 3.5mm cable.
Cat.6 Out 1 / 2 / 3 / 4: Connect to 4 separate receivers using Cat.6 or above network cable.
12VDC: Connect to the included power supply.
35404
VGA Out: Connect to a local VGA display.
Audio Out: Connect to a local audio output device using 3.5mm cable.
Cat.6 In: Connect to the VGA splitter using Cat.6 or above network cable.
EQ: Control and adjust the sharpness of the video output.
Gain: Control and adjust the brightness of the video output.
12VDC In: Connect to the included power supply.
For the installation please follow the steps below:
1. Connect a VGA display or projector to 1 or both VGA Output connections of the receiver.
2. Connect audio output devices to the receiver using 3.5mm audio cable.
3. Connect a Cat.6 or above network cable to the Cat.6 In port of the receiver.
4. Connect the opposing end of the Cat.6 cable to one of the 4 Cat.6 Out ports of the splitter.
5. For local VGA distribution, connect a VGA display and 3.5mm audio output to the VGA Out and 3.5mm
Out ports on the splitter.
6. Connect a VGA and 3.5mm audio source to the VGA and 3.5mm In ports of the transmitter.
7. Connect the included Multi-country PSU to the DC power jack of both the receiver and transmitter, and
plug into a mains power socket.
8. Switch on all connected devices.
Adjusting the Gain & Peak Settings
Use the two dials on the remote units labelled "EQ" and "Peak" to adjust the sharpness or brightness
respectively, to meet the users requirements.
Receiver
English