Save Hsm Settings To A Smartcard (Ss) - Thales payShield 10K Installation And User Manual

Save HSM Settings to a Smartcard (SS)

SS
Command:
Function: To save the Alarm, Host Port, Security, Audit, Command, and PIN Block settings to a
smartcard (RACCs are supported).
Authorization: The HSM must be in the secure state to run this command. Additionally, the HSM must
be either in the Authorized State, or the activity admin.console must be authorized,
using the Authorizing Officer cards of the Management LMK.
• Confirmation messages that Alarm, Host, Security, Audit, Command, and PIN Block
Outputs:
settings are saved.
• Card not formatted to save/retrieve HSM settings.
Errors:
Attempt with another card? [Y/N] - card is not formatted for storing HSM settings.
• Card not formatted. Attempt with another card? [Y/N] - card is not formatted.
• Command only allowed from Secure-Authorized - the HSM is not in Secure State, or
the HSM is not authorized to perform this operation, or both.
Example: Secure-AUTH> SS
Insert card and press ENTER:
ALARM settings saved to the smartcard.
HOST settings saved to the smartcard.
SECURITY settings saved to the smartcard.
AUDIT settings saved to the smartcard.
COMMAND settings saved to the smart card.
PIN BLOCK settings saved to the smart card.
Secure-AUTH>
©Thales Group
All Rights Reserved
payShield 10K Installation and User Guide
<Return>
Variant 
Online  Offline 
Authorization: Required
Activity: admin.console
<Return>
Key Block

Secure 
Page 352