Table of Contents
Advertisement
Installation
Exhaust ducting guide
Ducting
1. Make sure the dryer is installed properly so the air exhausts freely.
2. Use 4-inch rigid metal ducts. Tape all joints including the dryer connection. Never use lint-trapping
screws.
3. To facilitate the exhaust, keep the ducts as straight as possible.
Cleaning
Clean all old ducts before installing the dryer, and make sure the vent flap opens and closes freely. We
recommend that you clean the exhaust system annually or on a regular basis.
WARNING
• To prevent fire, do not use plastic, thin-foil, or non-metal flexible ducts of any kind.
• Do not use a poor exhaust system because it slows down the dryer's performance.
• Do not use excessively long ducts that have multiple elbows.
• Do not use crushed or clogged venting or ducts.
Door reversal
Type 1
34
English
Untitled-1 34
1. Put a soft rug on the floor to rest the door on after
you have removed it. This will prevent the door from
being scratched.
2. Unplug the power cord.
3. Remove two door hinge screws.
4. Lift the door and remove it.
NOTE
There is a screw on the back side of the hinge that will
support the door as you unscrew the hinge screws.
5. Remove the two screws that are above and below the
cut-out in the frame front.
2020-12-15
2:46:41
Advertisement
Table of Contents
