Emerson SR110 Owner's Manual page 5

BP7270-1 5/6/05 1:29 PM
4. For Ceiling Fan Models CF2500,
CF3900, CF4500 and CF4800 Only.
Remove two screws securing the
reversing switch to the switch housing
(Figure 2).
5. For Ceiling Fan Models F2100, F2200
and CF2300 Only. Remove the knurled
nut securing the reversing switch to the
switch housing (Figure 4).
Figure 4
6. For Ceiling Fan Models CF1 and
CF2800 Only. Locate
capacitor wire which is connected to
the yellow wire (gray wire on older
models) coming from the center of the
motor. Remove the wire connector and
separate the gray and yellow wires.
Cap the yellow wire using a wire
connector (supplied) (Figure 5).
CF1 & CF2800
YELLOW WIRE (GRAY
ON OLDER MODELS
AND ON CF2400)
Figure 5
6A. For Ceiling Fan Model CF2400
Only. Locate the gray capacitor wire
which is connected to the gray wire
coming from the center of the motor
(yellow wire on older models).
Remove the wire connector and
separate the gray wires. Cap the gray
wire using a wire connector (supplied)
(Figure 5).
Page 5
7. All Ceiling Fan Models. Separate the
capacitor (held in place with two-sided
tape) from the switch housing (Figure
2) and remove the wiring harness and
switch(es) from the switch housing.
NOTE: Keep the wiring harness if you
think you may like to return to manual
control in the future.
8. All Ceiling Fan Models. Close the
hole(s) for the speed control switch and
the uplight switch or reversing switch
by
(supplied) in the hole(s). (See Figures
2, 3, and 4). Choose the color that best
KNURLED
matches our ceiling fan.
NUT
9. Position
PULL
(supplied) in the switch cup; connect
CHAIN
the reversing module connector to the
PLUG
motor connector (Figure 6). The
connectors are color-coded and keyed
REVERSING SWITCH
and can be connected in only one
manner.
the gray
WHITE
CF1 & CF2800 INSTALL
REVERSING
WIRE CONNECTOR ON
MODULE WIRE
YELLOW WIRE
(CF2400 - INSTALL
REVERSING MODULE
WIRE CONNECTOR ON
CONNECTOR
GRAY WIRE)
Figure 6
GRAY
10. Using a wire connector (supplied),
CAPACITOR
connect the white wire from the motor
WIRE
to the reversing module white wire
(Figure 6).
CAPACITOR
11. Position the housing cover (Figure 2)
on the switch housing and secure
using the screws removed in Step 1.
NOTE: If you are planning to install an
optional Emerson Light Fixture on your
ceiling fan, do not install the housing
cover (Step 11) at this time.
12. Place the fan housing (top of motor
facing upward) in the lower styrofoam
pad. The lower pad serves as a
holder for the fan during the following
procedures.
5
installing pull chain plug(s)
the reversing module
WHITE MOTOR
WIRE CONNECTOR
WIRE
REVERSING
MODULE
MOTOR
CONNECTOR