Panasonic BT-WMA17G Installation Instructions Manual page 12

Installation procedure
2 )
Secure the wall mount adaptor.
Note
To prevent the LCD monitor from falling, always use
screws for securing wall mount adaptor A/B.
3 )
Adjust to a desired angle
The wall mount adaptor of the LCD monitor
can be adjusted in a range from 5° upward to
10° downward. To adjust the LCD monitor to a
desired angle, hold both the upper and lower
parts of the LCD monitor and then move it.
When adjusting the angle, take care not to
put stress to jacks, terminals, connectors, etc.
Otherwise, this may cause malfunction.
4 )
Secure the angle fixing screws
After adjusting the LCD monitor to a desired
angle, firmly tighten the angle fixing screws
(1.8 to 2.4 N·m).
Note
•
To change the angle, loosen the angle fixing screws.
•
Do not extend beyond 5° upward or 10° downward and
apply unnecessary force.
In some cases, this may cause malfunction or damage to
the LCD monitor, or damage to the adaptor/wall.
* After the installation, check again to make sure the
necessary parts are firmly attached.
12
To prevent the LCD monitor from
falling, use two screws for securing
wall mount adaptor A/B to secure
the left and right side of the LCD
monitor (1.8 to 2.4 N·m). If the
fixing holes of the two adaptors do
not match, the installation is not
well performed. In this case, install
again and make sure the fixing
holes do match, and then secure
the LCD monitor.
Temporarily tighten the angle
fixing screws.
continued
Screw for
Angle fixing
securing
screws
wall mount
adaptor A/B
Angle
fixing
screws