Lennox LI009HI-380P432 Owner's Manual page 18

Introduction for buttons on remote controller
the remote controller near the object of high temperature or low temperature in
order to avoid detecting inaccurate ambient temperature.
When I FEEL function is turned on, the remote controller should be put within the
area where indoor unit can receive the signal sent by the remote controller.
10
TIMER ON / TIMER OFF button
● TIMER ON button
"TIMER ON" button can set the time for timer on. After pressing this button, "
icon disappears and the word "ON" on remote controller blinks. Press "▲" or
" " button to adjust TIMER ON setting. After each pressing "▲" or "
TIMER ON setting will increase or decrease 1min. Hold "▲" or "
later, the time will change quickly until reaching your required time.
Press "TIMER ON" to confirm it. The word "ON" will stop blinking. "
resumes displaying. Cancel TIMER ON: Under the condition that TIMER ON is
started up, press "TIMER ON" button to cancel it.
● TIMER OFF button
"TIMER OFF" button can set the time for timer off. After pressing this button,"
icon disappears and the word "OFF" on remote controller blinks. Press "▲" or
" " button to adjust TIMER OFF setting. After each pressing "▲" or "
TIMER OFF setting will increase or decrease 1min. Hold "▲" or "
later, the time will change quickly until reaching your required time.
Press "TIMER OFF" word "OFF" will stop blinking. "
Cancel TIMER OFF. Under the condition that TIMER OFF is started up, press
"TIMER OFF" button to cancel it.
Note:
● Under on and off status, you can set TIMER OFF or TIMER ON simultaneously.
● Before setting TIMER ON or TIMER OFF, please adjust the clock time.
● After starting up TIMER ON or TIMER OFF, set the constant circulating valid.
After that, air conditioner will be turned on or turned off according to setting time.
ON/OFF button has no effect on setting. If you don't need this function, please
use remote controller to cancel it.
11
CLOCK button
Press this button to set clock time. "
"▲" or " " button within 5s to set clock time. Each pressing of "▲" or "
clock time will increase or decrease 1 minute. If hold "▲" or "
time will change quickly. Release this button when reaching your required time.
Press "CLOCK" button to confirm the time. "
Note:
● Clock time adopts 24-hour mode.
● The interval between two operations can't exceeds 5s. Otherwise, remote contro-
ller will quit setting status. Operation for TIMER ON/TIMER OFF is the same.
" icon on remote controller will blink. Press
" icon stops blinking.
11
" button, 2s
" icon
" button, 2s
" icon resumes displaying.
" button, 2s later,
"
" button,
"
" button,
" button,