Table of Contents
Advertisement
6-4.
NOTE FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS
Note on Printed Wiring Board:
• X : parts extracted from the component side.
• Y : parts extracted from the conductor side.
•
: Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side:
Parts on the pattern face side seen from
(Conductor Side)
the pattern face are indicated.
Parts face side:
Parts on the parts face side seen from
(Component Side) the parts face are indicated.
• Indication of transistor.
C
Q
These are omitted.
B
E
Q
B
C E
These are omitted.
All manuals and user guides at all-guides.com
Note on Schematic Diagram:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and
1
/
W or less unless otherwise
4
specified.
•
: internal component.
f
• 2 : nonflammable resistor.
• 5 : fusible resistor.
• C : panel designation.
Note: The components identified by mark 0 or dotted line
with mark 0 are critical for safety.
Replace only with part number specified.
• A : B+ Line.
• B : B– Line.
• Voltages and waveforms are dc with respect to ground
under no-signal conditions.
– BD Section –
no mark : CD PLAY
– Other Sections –
no mark : FM
∗
: Impossible to measure
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
F
: TUNER (FM/AM)
E
: TAPE PLAY (DECK A)
d
: TAPE PLAY (DECK B)
G
: REC
J
: CD PLAY
L : AUX IN
N
: MIC INPUT
• Abbreviation
E51
: Chilean and Peluvian models
MX
: Mexican model
• Circuit Boards Location
MOTOR (LD) board
CD KEY board
PANEL board
HEADPHONE board
23
23
SENSOR board
PT board
BD board
SW board
KEY board
MAIN board
CX-JN3
MOTOR (TB) board
TUNER PACK
DRIVER board
Advertisement
Table of Contents
