Page 5
Attach seat frame (2) to chair back (1) using bolt (C), spring washer (D) and washer (E) at the center point and bolts (A), spring washers (D) and washers (E) in the corners. Tighten all bolts (A,C) with wrench (H). Attach crossbars (6,7) to crossbar (5) using dowels as guides.
Page 6
Attach crossbars (6,7) with crossbar (5) to chair back (1) using dowels as guides. Attach legs (3,4) to the chair assembly using bolts (B), spring washers (D) and washers (E). Tighten all bolts (B) with wrench (H).
Page 7
Secure crossbars (6,7) to chair legs (3,4) and chair back (1) using screws (F). Tighten screws (F) with a screwdriver. Secure crossbar (5) to crossbars (6,7) using screws (G). Tighten screws (G) with a screwdriver.
Page 8
Attach seat (8) to seat frame (2) using screws (G).Tighten screws (G) with a screwdriver. Note: Seat (8) is not pre-drilled for screws (G) for added strength. Holes on seat bottom are not used for assembly.