Nowy Styl XIO 2.0 Original User Manual page 26

10. Error messages on the display
Symbol on the display
If an error cannot be fixed as described above, unplug the power supply, wait a few minutes, and try the
system initialisation / first start-up procedure again.
If the error persists, disconnect the power supply and contact Customer Service.
26 EN
Description
Conflicting operations on two differ-
ent controllers.
The "up" button hangs
The "down" button hangs
Voltage too low
Voltage too high
Parameter discrepancy
No legs at power-up
Count of legs doesn't match with the
current parameters
Reference movement required or
Initialisation movement is carried out.
Restart / first start-up required
Short circuit on DRIVE 1
The Sensor is calibrating
Note: If a power failure occurs or the power cord is pulled out during height adjust-
ment, initialization/start-up may be necessary.
Solution
Stop the operation of all elements connected
to the control module
Replace the control panel
Possible grid or power supply interference. Un-
plug the power supply. Contact the Customer
Service.
The controller does not match the number of
columns. Prepare information
about the device. Contact Customer Service
to check the parameters of the electrical set of
the workstation.
Reboot your system or use the F3 menue to
reset the parameters.
Proof all cables and use the F3 menue to reset
the parameters.
Carry out a reference movement.
Perform system initialisation / first start-up
following the user manual
Unplug the power supply. Check cables
connecting the column to the control module
for damage or connect the appropriate DRIVE
to the appropriate socket. If needed, perform
system initialisation / first start-up following
the user manual.
Please do not touch the table. This process
lasts a maximum of 5 seconds.