Contec CONPROSYS CPS-CNT-3202I Reference Manual page 48

Item
External power*1
LED
Match Signal Output point
Output
Output type
Output rating
Residual Voltage with
Output ON
Output signal width
Output protection circuit
External power
Connector
Applicable wire
LED
Current consumption
Physical dimensions (mm)
Weight
Installation method
*1 Use 5V or 12V power appropriately as an input resistance can be switched by DIP switch.
You can set the modules as you desire to the configurable controller up to 16 modules.
The total current consumption of the modules should be less than 3.3A.
Le nombre maximum de modules empilés en fonctionnement avec le contrôleur de type empilable
est de 16. La consommation totale de courant des modules doit être de moins de 3,3 A.
—
Appendix
CPS-CNT-3202I Reference Manual (Hardware)
5V ±5% or 12VDC ±10% Min. 200mA
DI (Green) x 2ch
1 x 2 channels
Opto-coupler isolated open collector output
35VDC (Max.), 50mA (per 1 point)
0.5V or less
0 - 104.45msec (All channels)
Zener diode CMZB47 (Toshiba) or equivalence
5V - 12VDC±10%
2 pieces 3.81mm pitch 10-pin terminal
AWG28 - 16
Status (Green, Red)
0.1A (Max.)
25.2(W)×94.7(D)×124.8(H) ( No projection included)
200g
Quick mounting on the 35mm DIN rail
CAUTION
ATTENTION
— 48 —
—
CPS- CNT-3202I