Table of Contents
Advertisement
INSTALLATION
Continued
Mantel Clearances for Built-In
Installation
If placing custom mantel above built-in firebox,
you must meet the minimum allowable clearance
between mantel shelf and top of firebox opening
shown in Figure 7. These are the minimum allow-
able mantel clearances for a safe installation. Use
larger clearances wherever possible to minimize
the heating of objects and materials placed on
the mantel.
CAUTION: Close screens
before operation of vent-free
gas log heater. Do not allow the
heater to touch or extend beyond
the fireplace screen.
If your installation does not meet the minimum
clearances in Figure 7, you must:
• raise the mantel to an acceptable height,
OR
• remove the mantel.
Note:
A ll vertical measurements
are from top of fireplace
opening to bottom of mantel
shelf. All measurements
are in inches.
Facing material (above
firebox) may be of
combustible material,
including decorative
mantel ornaments.
Firebox
Wire-mesh
Screen
Figure 7 - Minimum Mantel Clearances
for Built-In Installation
INSTALLING BLOWER ACCESSORY
You may install blower accessory GA3750A with
conventional installation (below) or with built-in
installation (see Built-In Installation of Blower
Accessory). To install blower accessory, see in-
struction sheet included with the kit.
8
Mantel Shelf
10"
8"
6"
2
1 /2
"
For
CGFB32C
Series
13" 16"
19"
21"
circulating
louvered
models
only
Supplied
Firebox Hood
Must Be Used
at All Times
www.desatech.com
Blower
Blower Power
Cord
Figure 8 - Routing Blower Accessory
Power Cord for Conventional Installation
Electrical
Outlet
Side
Opening
Support Bracket
Opening
107331-01H
Advertisement
Table of Contents
