Chapter 3 Operation Method - Pro XK3190-DS3 Operation Command

be ASCII code letter for sending, for example, Xor checking four higher bit is B. With 37h added, it is
42h, i.e. letter B in ASCII code for sending out.
3. Command list sent by host computer (set address of the indicator as 01):
Content of Command Host computer sends out commands (hexadecimal)
Category
Command A Hand shaking
Command B Reading gross weight 02 41 42 30 33 03
Command C Reading tare
Command D Reading net weight
4. Indicator communication parameter setting:
(1). Communication parameters
Communication parameters are made up of three groups of parameters, i.e. communication address, baud
rate and communication method.
(2) Steps for setting communication parameters:
Step Operation
1
Press [Parameter
setting]
2
Press [9][8]
Press [Input]
3
Press [1]
Press [Input]
4
Press [1]
Press [Input]
5
Press [0]
Press [Input]
6
Note 2: In the old D2+ continuous communication format, data is output in form of ASC code with 8
bits in every frame (including the decimal point). Lower bits of the data are sent at first and then
the higher ones. The frames are divided by "=". Data being sent is the net weight (i.e. the value
displayed on indicator), for example, when the value 70.15 is displayed, the indicator
continuously sends out 51.0700＝51.0700＝51.0700.......
In the new D2+ (300 tons) continuous communication format, data is output in form of
ASC code with 9 bits in every frame (including the decimal point). Lower bits of the data are
Ⅱ
sent at first and then the higher ones. The frames are divided by "=". Data being sent is the net
weight (i.e. the value displayed on indicator), for example, when the value 70.15 is displayed,
the indicator continuously sends out 51.07000＝51.07000＝51.07000......
X K 3 1 9 0 –DS3
02 41 41 30 30 03
02 41 43 30 32 03
02 41 44 30 35 03
Displayed content
In the weighing and
displaying state
[ P 00 ] Input the setting password "98"
[ P 98 ]
[ Ad r ** ]
Address ( 01～26 )
[ Ad r 01]
E.g.: 1
[ b t * ] Baud rates of serial communication (0~4)
means following baud rates respectively:
[ b t 1] 600, 1200, 2400, 4800 and 9600 baud rates.
E.g.:1
[ t F * ] Way of serial communication:
[ t F 0 ]
format, 8 bits every frame
format, 9 bits every frame
（See Note 2）
E.g. 0
Weighing state Communication parameter setting is
completed
Chapter 3 Operation Method
(7)
Note
0—Continuous send mode, no reception
1—Appointed answering mode
2—Old D2+ continuous communication
3—New D2+ continuous communication
Ⅱ