Lighting Instruction - KEKAI NOVA SLIM Instruction Manual

Heater Operation instructions:

Lighting instruction:

The heater can be regulated to three different settings: 1-LOW, 2-MEDIUM and 3-HIGH. Ignition mode:
piezo ignition.
• Open the valve on the heater cylinder 1 and 1/2 turns.
• Press down and turn the control knob to 1-LOW position and hold for 10 seconds.
• While still pressing down the pilot light, press once or twice on the ignition button until the pilot light (at
the bottom of the burner) ignites. Continue to hold the control knob down for 10-15 seconds
more.Release the button, and if the pilot flame goes out, repeat the above operation.
Note: when lighting a new heater for the first time, it might be necessary to hold the control knob down
for longer time in order to allow gas to flow to the pilot.
Once the heater in on at the 1-LOW setting, turning the control knob to 2-MEDIUM or 3-HIGH
positionwill light the second and third panel respectively.
To turn off the heater, turn back the control knob to the OFF position and close the cylinder valve
fully(clockwise). The heater can only be turned off by closing the cylinder valve. It can not be turned
offby the control knob.
Operating the quatz:
Operation the heater according to following procedures when electric power is use.
The electric heating system is designed with technology of infrared radiation. Even if it is used inan
unsealed and large size room, heating efficiency will be perfect.
1.Make sure plug is normally earthed. Put plug in the socket
2.Press switch to start the top quartz tube.
3.Press switch to start the other two quartz tubes.
4.Press switch and to start all quartz tubes. Heat load reaches to peak.
5.Turn all switch off after use. Remove the plug from the socket.
As shown in below Figure
Note:
To prevent too high temperature near the air-outlet grilles, it is recommended that in the use of gasand
the electric heating elements in the heater should not be used at the same time.
14