KEKAI NOVA SLIM Instruction Manual page 13

 IT DOES NOT PROTECT TOTALLY YOUNG CHILDREN AND DISABLED PEOPLE.
 Keep these people away from the device when it is operating.
 In the event of a gas leak, the auxiliary heater must be switched off and the gas cylinder valve
closed by means of a wet mop / cloth
 Never use a flame to check for gas leakage.
 Even if your gas cylinder appears to be empty,gas may remain. Transport and store the
cylinder properly.
 The appliance must not be located immediately below a socket outlet.
 Do not use the heater in the immediate surroundings of a bath, a shower or a swimming pool.
 Do not use this heater with a programmer, timer or any other device that switches the heater
on automatically, since a fire risk exists if the heater is covered or positioned incorrectly.
 This appliance should not be used by children younger than 8 years of age and by people with
reduced physical, sensor and mental capabilities, as well as by people with insufficient
experience and knowledge provided they are supervised or instructed in safe operation of the
appliance and understand the related risk.
 Children should not be allowed to play with the appliance.

Cleaning and user maintenance operations must not be carried out by children without
supervision.
Heater set-up
1. After the heater has been removed from its package, remove the back panel from inside the
back cavity.
2. Place the filled gas cylinder into the back of the heater with the valve outlet facing outwards.
3. Screw the correct regulator onto the outlet of the gas cylinder valve clockwise. Turn by hand only.
Do not use a spanner. Screw on until the nut is fully home.
4. IMPORTANT TEST for leaks:
This must be carried out in a well-ventilated area, free from any open flames or other sources of
ignition. With the regulator connected to the cylinder, turn on the gas cylinder valve 1 and 1/2
turns anti-clockwise.
Brush all hose connections, pipe connections to the gas valve, regulator connection to the
cylinder and gas cylinder valve with a 50:50 solution of detergent and water. A stream of bubbles
forming is an indication of a leak. If a leak is found, turn off the cylinder valve (clockwise),
disconnect the regulator from the gas cylinder and remove the gas cylinder to a cool, outdoor
well-ventilated area. Contact your dealer or gas supplier for assistance.
DO NOT USE THE HEATER IF A LEAK IS FOUND.
DO NOT USE A NAKED FLAME FOR LEAK TESTING.
DO NOT OPERATE ANY ELECTRICAL EQUIPMENT IN THE PRESENCE
OF A GAS LEAK.
5. After leak-testing is satisfactorily carried out, fit the rear panel onto the heater. It may be
necessary to twist the cylinder slightly to allow the regulator and hose to fit inside the back panel
without kinking the hose.
Note: The heater incorporates several safety devices that will shut down the heater in unsafe conditions.
In case of accidental flame failure, the gas heater will shut down automatically. These con-device will
turn off the heater if it is tipped over, if this activate, set the heater upright, check for obvious damage
and again wait 5-10 minutes before attempting to tore-light the heater. This device may also operate if
the heater is knocked against or bumped.
12