Operating The She4Am0/1; To Start Unit; Child Lock; Setting Options - Bosch SHE4AM Use And Care Manual

OPERATING THE:
SHE4AM0
SHE4AM1

To start unit:

- Door must be closed. press the on/off button to turn the unit on.
- Program LEDs will be flashing to indicate "pre-select" mode.
- press or to select desired cycle.
- If desired press "Delay start" to select 3/6/9 hour delayed start. If desired press the Half Load option (SHE4AM1 models only)
- Press start to begin cycle. Program select LED stops flashing and Active LED illuminates.
NOTE: Rinse Agent LED will be illuminated if unit needs rinse agent.

Child Lock

- after pressing start you can activate the Child lock feature.
- press and hold until "Child lock" leD illuminates. leD goes off once you release the button. Child lock is activated. now
any button you press (except on/off) will not function and the child lock leD will illuminate each time to indicate this
- to deactivate: press and hold
WARNING
You could be seriously scalded if you allow hot water to splash out of the dishwasher. OPEN THE DOOR CAREFULLY during
any wash or rinse cycle. Do not fully open the door until water noises have stopped.
To cancel cycle:
NOTE: Child lock needs to be deactivated
- Press and hold the "Start Reset " button for 3 seconds.
the unit will drain any remaining water ( takes about 1 minute), active leD goes out and Clean leD illuminates.
- turn unit off.
Setting Options (Extra Dry Heat / Rinse Agent Amount)
- Door must be closed. turn unit on.
- Wash cycle LED will be flashing to indicate pre-select mode.
- To enter "setup" mode press and hold
- Clean and one other LED will be flashing to indicate setup mode.
-
press to select an option (extra Dry Heat / rinse agent amount)
- press to adjust the setting for the respective option.
to set extra Dry Heat: Clean & Sanitized LED flashing
power scrub Heat setting
extra Dry on
extra Dry off
- press to switch between the Heat and rinse agent options.
- press start to save
to set rinse agent amount: Clean + Rinse Agent LED flashing
until the child lock leD goes out.
then press and release "Start Reset" button; then release
power
sHe4aM0
scrub
power
sHe4aM1
scrub
.
regular Quick rinse &
Wash Wash Hold
auto regular Quick
Wash Wash Wash
rinse aid
setting
0
1
2
3
13