Table of Contents
Advertisement
en Operating the appliance
1
Operating the
appliance
P rogramme data
O p e r a t i n g t h e a p p l i a n c e
The programme data (consumption
values) can be found in the quick
reference guide. They refer to normal
conditions and the set water hardness
value •:‹.... Different influencing factors
such as water temperature or line
pressure may result in deviations.
Changing the settings
The dishwasher has been preset with
certain settings for your convenience.
You can change these factory settings.
Here's how to change the settings:
Switch on ON/OFF switch (.
1.
Press and hold the ‹ button
2.
for 3 seconds.
In the display window @ you will
see •:‹... and ' .
Press the ‹ button to access
3.
the individual settings.
Adjust the setting using the buttons -
4.
and + H.
Press and hold the ‹ button
5.
for 3 seconds.
The chosen setting has now been
stored in your dishwasher.
If you want to change a number of
Tip:
settings, first make all your changes one
after another. Then press the ‹
button for 3 seconds. All the settings
will then be stored in the dishwasher.
30
AquaSensor *
* depending on the features of your
A q u a S e n s o r
dishwasher
The Aqua sensor is an optical
measuring device (light barrier) which
measures the turbidity of the rinsing
water.
The AquaSensor is used according
to the programme. If the AquaSensor is
active, "clean" rinsing water can be
transferred to the next rinse bath and
water consumption can be reduced by
3–6 litres. If the turbidity is greater,
the water is drained and is replaced
with fresh water. In the automatic
programmes the temperature
and running time can also be adjusted
to the degree of soiling.
Sensor setting
In its automatic programmes the
appliance uses sensors to optimise
their operation. The sensors adjust the
strength of the automatic programmes
according to the amount and type of
soiling. You can choose from three
levels of sensitivity for the sensors.
Sensor setting †":‹‹: This setting is
ideal for a mixed load and heavily soiled
utensils, but it also saves energy and
water.
Sensor setting †":‹‚: This setting
adjusts the programme strength for the
effective removal of food remnants,
even if the amount of soiling is low. The
energy and water consumption is
adjusted accordingly.
Sensor setting †":‹ƒ: This setting
adjusts the programme strength for
difficult conditions of use, for example
firmly dried on food remnants. This
setting is recommended if you are using
biological or eco detergents which
contain smaller quantities of active
agents. The energy and water
consumption is adjusted accordingly.
Advertisement
Table of Contents
