Table of Contents
Advertisement
22K ohm 0805 SMT resistor (marked "223")
__
1
__
4
.1 uF 0805 SMT multilayer ceramic capacitors (brown in paper carrier)
__
1
10 uF 1206-size capacitors (brown in clear plastic carrier)
__
1
6mm x 3mm push button switch
__
1
10mm magnetic buzzer
__
1
3-pin header
1/32" Brass Antenna Wire (4")
__
1
3 ½" length of 1/16" heat-shrink tubing
__
1
Coil of .020" 63/37 No-Clean solder wire
__
1
Note that you will find that you got a few more 0805-size components that you actually need.
This is intentional... in case you drop one. Those buggers are small, and REALLY easy to
lose if you're not careful. Therefore, DO NOT remove them from the tape that they come in
until you're ready to install it. Remove one part at a time, solder it in, then go onto the next
one. If you try to remove them all at the same time, you will get them mixed up, or lost.
Advertisement
Table of Contents
Need help?
Do you have a question about the Eggtimer TRS and is the answer not in the manual?
Questions and answers