Advertisement
Connection
17. Use
Connect this kit according to the wiring diagram. LED LD1 will light if the
operating voltage is correct. Take all necessary precautions to avoid
electroshocks when connecting cold-cathode fluorescent lamps : the
inverter 'FLPS1' uses a potentially life-threatening voltage.
F
This kit is available in various countries. Take care to use
an appropriate connection or adapter.
Selecting a light effect :
Push button SW1 'Effect select' allows you to choose one of ten avail-
able programmes. Hold SW1 to see which effect is currently selected :
the LED of that effect will light. The light effect will start running when you
release SW1. Press SW1 momentarily to select the next light effect.
SW2 enables you to activate or deactivate all channels. Press SW1 to
restart the selected light effect.
Adjust the speed of the running light with RV1
F
The connection cables should be equipped with an appropri-
ate strain relief when mounted in a movable housing.
Random light effect :
Hold SW2 pressed before connecting the power supply (the
other light patterns shall not work!).
Number of connected channels :
Mount a jumper wire on the spot that matches the amount of
!
light channels you would like to use. This will make some light
effects adjust to the number of channels used.
Example : Mount a jumper wire on 5 CH if you wish to use 5
light channels.
12
Advertisement
