Adding Salt; Detergent - Beko EDIN Series User Manual

Adding salt

Use only special softening salts
produced particularly for the dishwashers in
your machine.
1. First take the lower basket out to add
softening salt.
2. Turn the salt reservoir lid counter-
clockwise to open it (A).
3. Add 1 litre of water to salt reservoir of
your machine only in initial use.
4. Add salt to the salt compartment. To
speed up dissolution rate of salt in
water, stir it with a spoon.
You can put about 2 kg of softening
salt into the salt reservoir.
5. Replace the lid and tighten it when the
reservoir is full.
You need to add salt right before
starting the machine. Thus, the
overflowing salty water will be flushed
immediately, preventing the risk
of corrosion in machine. In cases
where you would not start washing
immediately, run your machine empty
in the shortest program.
Since different salt brands in the
market have different particle sizes and
since the water hardness may vary,
dissolution of the salt in water may
take a couple of hours. Therefore, Salt
Indicator remains on for a while after
adding salt into the machine.
16/EN

Detergent

You can use powder, tablet and liquid/gel
detergent in the machine.
Only use the detergents produced
particularly for use with dishwashers in
the machine. We recommend you not
to use detergents that contain chlorine
and phosphate as they are harmful for
the environment.
Your dishwasher is equipped with an
Automatic Liquid/Gel Detergent Dosing
System.
Thanks to this system, the amount of rinse
aid and liquid/gel detergent required for the
selected washing programme is adjusted
automatically.
Please read the information given
in section "Operating the Product" to
activate or deactivate the Automatic
Liquid/Gel Detergent Dosing
adjustment.
When the Automatic Liquid/Gel
Detergent function is enabled, the
Automatic Liquid/Gel Detergent
indicator on the panel will light up if
there is liquid/gel detergent in the
detergent box. If there is little or no
detergent in the detergent box, the
indicator will flash.
When the Automatic Liquid/Gel
Detergent indicator starts to flash,
there is enough detergent for at least 5
washing cycles.
• Factory settings of the Automatic
Liquid/Gel Detergent Dosing
System are based on the detergent
amount recommended by detergent
manufacturers.
• You can proceed to the Settings menu
to change the Automatic Liquid/Gel
Detergent Dosing setting according
to your habits, or according to the
recommendations by the detergent