Panel Installation - ActronAir Cascade URC-071AS Installation Manual

10. Panel Installation

The Installation of the Panel
CAUTION
• DO NOT place the panel face down on the floor, against
a wall, or on uneven surfaces.
Step 1: Remove the front Grille
1. Push both of the tabs towards the middle
simultaneously to unlock the hook on the grille. .
Fig. 10.1
2. Insert the screwdriver into the joint. Pull the link spring
up at the left side and loosen the suspension wire.
(Fig.10.2 and Fig.10.3)
Suspension wire
Pulley
Fig. 10.2
(Left)
Loosen the wire
Take the wire off the gap
Fig. 10.3
3. Take the suspension wire off the pulley at the left side.
(Fig.10.3)
4. Take off the suspension wire at the right side same as
the left side.
5. Take off the suspension wire at the other side same as
the above four steps.
Pulley
Joint Link Spring (Right)
Super Slim Four-Way Cassette
Step 2: Remove the installation covers at the four corners
by sliding them outwards
Step 3: Install the Panel
1. Align the front panel to the main body, taking into
account the position of the piping and drain sides.
Hang the four latches of the decorative panel to the
hooks of the indoor unit. Tighten the panel hook
screws evenly at the four corners. (See Fig 10.5)
NOTE
Tighten the screws until the thickness of the sponge
between the main body and the panel reduces to 4-6mm.
The edge of the panel should be in contact with the
ceiling well.
2. Adjust the panel by turning it to the arrow direction
(See Fig 10.5) so that the ceiling opening is completely
covered.
Page 28
Fig. 10.4
Fig. 10.5