Electrical Connection - Miele WTD160 WCS 8/5 KG WT1 Installation Manual

Electrical connection

The washer-dryer is supplied with a
mains cable with moulded plug ready
for connection to a suitable earthed
socket.
The socket must be easily accessible
after the washer-dryer has been
installed. If that is not possible, ensure
that a suitable means of disconnection
is provided on the installation side for
each pole.

Risk of fire from overheating.
Connecting the washer-dryer to a
multi-socket adapter or to an
extension lead can overload the
cable.
For safety reasons, do not use an
extension lead or multi-socket
adapter.
The electrical system must comply with
local and national safety regulations
(BS 7671 in the UK). We recommend
the use of a suitable RCD .
If the mains connection cable is
damaged, it must only be replaced with
a specific mains connection cable of
the same type (available from the Miele
Customer Service Department). For
safety reasons, such replacement may
only be carried out by a qualified
technician or the Miele Customer
Service Department.
11887140-00
These operating instructions and the
data plate indicate the nominal power
consumption and the appropriate fuse
rating. Compare this information with
the data of the on-site electrical
connection.
If in any doubt, consult a qualified
electrician.
Do not connect the washer-dryer to a
stand-alone inverter such as those used
with an autonomous power supply, e.g.
solar power. When the washer-dryer is
switched on, power surges could result
in a safety switch-off. This could
damage the electronic module.
Installation