Before connecting the machine to the power line, make sure the switch (s) is in the "OFF" position and be sure that the electric current is of the same characteristics as indicated on the machine. All line
connections should make good contact. Running on low voltage will damage the machine.
DO NOT EXPOSE THE MACHINE TO RAIN OR OPERATE THE MACHINE IN DAMP LOCATIONS.
Before connecting the machine to the power source, make sure the switch is in the "OFF" position.
THIS MACHINE MUST BE GROUNDED WHILE IN USE TO PROTECT THE OPERATOR FROM ELECTRIC SHOCK
All grounded, cord-connected machines:
In the event of a malfunction or breakdown, grounding provides a path of least resistance for
electric current to reduce the risk of electric shock. This machine is equipped with an electric cord
having an equipment grounding conductor and a grounding plug. The plug must be plugged into
a matching outlet that is properly installed and grounded in accordance with all local codes and
Do not modify the plug provided - if it will not fit the outlet, have the proper outlet installed by a
qualified electrician. Improper connection of the equipment-grounding conductor can result in risk
of electric shock. If repair or replacement of the electric cord or plug is necessary, do not connect
the equipment-grounding conductor to a live terminal.
Check with a qualified electrician or service personnel if the grounding inst ruct ions are not
completely understood, or if in doubt as to whether the machine is properly grounded. Use only
3-wire extension cords that have 3-prong grounding type plugs and matching 3-conductor
receptacles that accept the machine's plug.Repair or replace damaged or worn cord immediately.
Model BT1800 is a 10" Table Saw designed to give high quality performance with depth of cut
capacity up to 3" (76mm) at 90° and 2-1/2" (63 mm) at 45° for clean cutting of standard stock
sizes. BT1800 includes the saw with a 1500W, a metal stand, rip fence, miter gauge , see-through
blade guard with splitter and anti-kickback fingers, a 10" carbidetipped saw blade, table insert and
Use proper extension cords. Make sure your extension cord is in good condition
and is a 3-wire extension cord which has a 3-prong grounding type plug and matching receptacle
which will accept the machine's plug. When using an extension cord, be sure to use one heavy
enough to carry the current of the machine. An undersized cord will cause a drop in line voltage,
resulting in loss of power and overheating.
IN ALL CASES, MAKE CERTAIN THE RECEPTACLE IN
QUESTION IS PROPERLY GROUNDED. IF YOU ARE NOT SURE HAVE A
QUALIFIED ELECTRICIAN CHECK THE RECEPTACLE.
NOTICE: THE PHOTO AND ILLUSTRATIONS CONTAINED IN THE MANUAL
ARE REPRESENTATIVE ONLY AND MAY NOT DEPICT THE ACTUAL COLOR,
LABELING OR ACCESSORIES AND ARE INTENDED TO ILLUSTRATE