Honda Goldwing GL1800 2019 Owner's Manual page 178

Engine Oil u Changing Clutch Oil Filter
Changing Clutch Oil Filter
GL1800BD/DA
Use a new Honda Genuine clutch oil filter
or equivalent specified for your model.
NOTICE
Using the wrong clutch oil filter can result in serious
damage to the transmission.
1. Follow the steps 1- 6 of Changing
Engine Oil & Filter.
2
2. Place a drain pan under the clutch oil
filter cover.
3. Remove the clutch oil filter cover,
spring and clutch oil filter by removing
the oil filter cover bolts.
Discard the oil and clutch oil filter at
u
an approved recycling centre.
174
Rubber seal
P. 172
Cover bolts
4. Install a new clutch oil filter with the
rubber seal facing in, toward the
engine. You will see "OUT-SIDE" mark
on the clutch oil filter body, toward the
filter cover.
5. Replace the O-ring and apply a thin
coat of engine oil to new O-ring before
installing it.
6. Install the spring and the clutch oil filter
cover.
7. Install the clutch oil filter cover bolts
8. Apply a thin coat of engine oil to the
Clutch
oil filter
9. Install the new engine oil filter and
"OUT-SIDE"
10. Replace the sealing washers with new
Spring
11. Fill the crankcase with the
Oil filter cover/O-ring
12. Check the oil level. (
13. Check that there are no oil leaks.
and tighten.
rubber seal of a new engine oil filter.
P. 173
2
tighten.
Torque: 26 N·m (2.7 kgf·m, 19 lbf·ft)
ones. Install the drain bolts and tighten
them. P. 172
2
Torque: 30 N·m (3.1 kgf·m, 22 lbf·ft)
recommended oil ( P. 159, 253, 255)
2
and install the oil fill cap.
Required oil:
When changing oil, engine oil
filter & clutch oil filter:
4.6 litres (4.9 US qt, 4.0 Imp qt)
P. 171)
2