Stihl MS 231 Manual page 78

Models with manual fuel pump
1
: Remove the fuel hose (1).
All models
1
2
: Carefully pull the carburetor (1)
off the studs – take care not to
overstretch the fuel hose (2).
– Put the carburetor with fuel hose
still attached to one side.
1
: Pry the throttle rod (1) out of the
carburetor carrier (2).
MS 231, MS 231 C, MS 251, MS 251 C
All manuals and user guides at all-guides.com
: Pass the throttle cable (1)
through the opening (arrow) in
the direction of the rear handle.
– Check the throttle rod and
replace if necessary
Installing
: Pass the throttle cable (1)
between tank and engine
housings and through the
opening (arrow) in the direction
of the rear handle.
2
: Push the throttle rod (1) into the
guide (2) in the carburetor carrier
until it snaps into position.
– Install the throttle trigger, b 10.2
1
2
: Push the carburetor (1) with fuel
hose (2) over the studs
– take care not to overstretch the
fuel hose (2).
Models with manual fuel pump
1
: Fit the new fuel hose (1).
All models
– Install the filter base, b 12.3
1
– Check operation
– the throttle lever on the
carburetor must move upwards
when then throttle trigger is
2
pulled.
– Reassemble all other parts in the
reverse sequence.
1
1
77