Bissell SPOTBOT 1200/7887 User Manual page 8

O
peration
How to begin continued
1.
Surface Stain Cycle This cycle has been
designed for stains that are on the surface of
your carpeting and have not had time to
penetrate deep in to your carpet fibers. This
cycle will run for approximately 3 minutes.
2.
Set-In Stain Cycle Use on stains that have
had a period of time to set-in and penetrate
deep into your carpet fibers. These are typically
the most difficult stain types to remove. This
cycle runs for approximately 6 minutes.
3.
Manual / Hose By selecting this option you can
clean spots and stains manually on surfaces
such as upholstery, car interiors, stairs or
anyplace you have a need to clean manually
4.
Pause/Resume Is used to check the
status of a cleaning cycle (Surface Stain or
Set-In). If you hit the Pause button once, it
pauses the cleaning cycle it is currently in.
By pressing it one more time to Resume,
you will pick up in the cleaning cycle
where you left off.
5.
Stop By depressing the Stop button, you
will stop your SpotBot in either the Surface
or Set-In stain cycle. To begin cleaning
again, you will need to select one of the 2
cycles.
6.
Status Indicators Much like the
dishwasher in your kitchen, the Status
Indicators will instruct you as to what is
going on within a cleaning cycle. You will
hear changes in the sound of the machine
at different points in a cycle. When your
selected cleaning cycle is complete, the
Finish light will illuminate and you will
hear a "beep" every 5 seconds until you
depress the stop button.
8
w w w . b i s s e l l . c o m
ug120-4070_1200_408.indd 8
Tip:
Some spots and spills
require that you pick up the
chunky debris with a rag
or towel before you begin
cleaning in the Handsfree or
Manual cycles.
8 0 0 . 2 3 7 . 7 6 9 1
10/14/08 1:07:43 PM