Matco Tools MWLHHTL Manual

MINI TWIN HEAD
WORK LIGHT
PLEASE READ CAREFULLY & FOLLOW DIRECTIONS BEFORE USE
BEFORE INITIAL USE - CHARGE BATTERY PACK FOR 4-8 HOURS

CHARGING INSTRUCTIONS:

1. Lift rubber cover on side of the light, insert Micro USB into light and insert USB end into
USB power outlet (5V 1A).
2. Charging indicator will turn on, RED LED = charging in progress, GREEN LED = fully charged.
3. Remove Micro USB cable after fully charged and insert rubber cover into charging port.

OPERATING INSTRUCTIONS:

1. Push and release power button to cycle through high mode, low mode, and off.
2. Each light head can be independently adjusted to seven (7) angled positions.
3. Magnetic belt clip can be rotated 180°. Built-in hook and the magnet can be used for mounting.

REPLACEMENT COMPONENTS / ACCESSORIES:

FS60699 - Replacement Hook
FS99368 - USB Cord
FS99370 - USB Wall Adapter (Optional Accessory)

GENERAL GUIDELINES AND WARNINGS:

• Improper handling of the device may result in fire, personal injury, or property damage.
• Never charge device unattended. Do not charge on or near flammable material. Only charge using
included USB cable or USB compliant cable.
• If device begins to balloon, swell, or smoke, discontinue using or charging immediately and observe
device in a safe place.
• Do not short-circuit, crush, incinerate, or disassemble the device.
• Do not use if device or charging cable are damaged.
• Do not dispose of batteries in trash. Always recycle batteries according to national or local regulations.
• The integrated battery should not be exposed to excessive heat such as sunshine, fire, etc.
• For optimal battery life, device should be operated and stored between 40 F - 80 F
WARNING: Cancer and Reproductive Harm. www.P65Warnings.ca.gov
Matco Tools | Stow, Ohio 44224
®
www.matcotools.com
MWLHHTL
1902071-08