Advertisement
STEP 4
FIG 7
STEP 5
FIG 8
After you removed an old seat from riser, reuse those bolts for reattachment. Inspect all bolts
and replace, if missing or damaged, with grade 8 bolts or stronger. One bolt in each corner
must be used (4 total) for mounting. The bolt holes in the internal frame of the seat are meant
to accomodate multiple sized risers (not included). (Fig 8) Refer to factory service manual for
specific torque specifications.
SEATS MUST BE SECURELY BOLTED AT ALL PRIOR BOLT LOCATIONS.
Using a 13mm socket or wrench, tighten bolts
to hold bracket (Fig 7). Do not fully tighten at
this time.
Repeat previous steps for other side.
After both sides are attached, tighten each bolt
securely.
5
Advertisement
