Setting Parameters Before Using The Snmp Management - La Marche DCPS Installation And Operation Manual

Main Menu

5.6.2 Setting Parameters before Using the SNMP Management

Procedure
Step 1 Apply to the site or equipment room network administrator for a fixed IP address.
Step 2 Set the IP address, subnet mask, and gateway on the LCD of the DCSC, as described in
Table 16.
Main Menu
Setting Wizard
Connect the network port on your laptop to the FE port on the DCSC by using a network cable.
CAUTION
:
There is only one FE port on the DCSC. Before performing step 3, disconnect the original cable from the
FE port and then reconnect it after performing the following steps.
Second-Level Third-Level
Menu Menu
Default
Gateway
Table 15 – IP parameters
Second-Level Third-Level
Menu Menu
Network IP Address
Parameters
Subnet Mask
Default
Gateway
Table 16 – IP parameters
Default Value Setting Value
network
administrator.
192.168.0.1 Set this
parameter based
on the address
assigned by the
network
administrator.
Default Value Setting Value
192.168.0.10 Set this
parameter based
on the address
assigned by the
network
administrator.
255.255.255.0 Set this
parameter based
on the address
assigned by the
network
administrator.
192.168.0.1 Set this
parameter based
on the address
assigned by the
network
administrator.
26