DeWalt DCN701 Manual page 12

English
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual before use.
Wear ear protection.
Wear eye protection.
Visible radiation. Do not stare into light.
Only for cable staples
CABLE
STAPLE
Length of staples.
25 mm
Loading capacity.
35
Electric shock
Date Code Position (Fig. A)
The date code , which also includes the year of manufacture,
11
is printed into the housing.
Example:
2020 XX XX
Year of Manufacture
Description (Fig. A)

WARNING: Never modify the power tool or any part of it.
Damage or personal injury could result.
Trigger
1
Utility hook
2
Cable alignment guide
3
Wire indicator
4
Headlight/LED work light
5
Intended Use
Your cable stapler is intended OnlY for use in driving staples
into wood.
DO nOT use under wet conditions or in the presence of
flammable liquids or gases.
This cable stapler is a professional power tool.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
• Young children and the infirm. This appliance is not
intended for use by young children or infirm persons
without supervision.
• This product is not intended for use by persons (including
children) suffering from diminished physical, sensory or
mental abilities; lack of experience, knowledge or skills
10
Magazine
6
Magazine release button
7
Pusher
8
Battery release button
9
Battery
10
unless they are supervised by a person responsible for their
safety. Children should never be left alone with this product.
Dry Fire Lock Out
Your stapler is equipped with a dry fire lockout which prevents
the tool from actuating when the magazine is empty. After the
last staple is fired the tool ceases to operate. Refer to Loading
the Tool to reload a stick of collated staples.
ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before loading staples, making any adjustments or
removing/installing attachments or accessories. An
accidental actuation can cause injury.

WARNING: Use only D
Inserting and Removing the Battery Pack
from the Tool (Fig. B)
nOTE: Make sure your battery pack
To Install the Battery Pack into the Tool Handle
1. Align the battery pack 10
handle (Fig. B).
2. Slide it into the handle until the battery pack is firmly seated
in the tool and ensure that you hear the lock snap into place.
To Remove the Battery Pack from the Tool
1. Press the release button
out of the tool handle.
2. Insert battery pack into the charger as described in the
charger section of this manual.
Fuel Gauge Battery Packs (Fig. B)
Some D WALT battery packs include a fuel gauge which
e
consists of three green LED lights that indicate the level of
charge remaining in the battery pack.
To actuate the fuel gauge, press and hold the fuel gauge
button . A combination of the three green LED lights will
12
illuminate designating the level of charge left. When the level
of charge in the battery is below the usable limit, the fuel gauge
will not illuminate and the battery will need to be recharged.
nOTE: The fuel gauge is only an indication of the charge left on
the battery pack. It does not indicate tool functionality and is
subject to variation based on product components, temperature
and end-user application.
Utility Hook (Fig. C)
The D WALT cordless stapler includes an integrated utility
e
hook and can be installed on either side of the tool to
2
accommodate left- or right-handed users.
If the hook is not desired at all, it can be removed from the tool.
To Install the Utility Hook
1. Remove staples and battery pack from tool.
2. Using only the provided screw
be be installed on either side of the tool. To switch the tool
WALT battery packs and chargers.
e
10 is fully charged.
with the rails inside the tool's
and firmly pull the battery pack
9
, the utility hook
13
can
2