Solution Suggestions For Problems - Beko DRCS 76 S Installation & Operating Instructions And Drying Guidance

9

Solution suggestions for problems

Problem
Drying process
takes too much
have not been cleaned.
time.
* Cover filter and filter drawer might
Laundry come out
have not been cleaned.
wet at the end of
* Excessive laundry might have been
drying.
loaded in.
* It might have not been plugged in.
* The loading door may be ajar.
Machine does not * Programme might have not been set
switch on or the or the "Start/Pause/Cancel" button
programme does might have not been pressed.
not start. Machine * "Childproof lock" might have been
is not activated activated.
when set. * The condenser cover on the models
with a condenser might not be closed
securely.
Programme has
* The loading door may be ajar.
been interrupted
* Electricity may be cut off.
without any cause.
Laundry has
shrunk, become * A programme suitable for the laundry
felted or type might have not been used.
deteriorated.
Drum lightning
does not come on. * The machine might have not been
(for models started by using the On/Off button.
equipped with a * Bulb may have blown.
lamp)
"Final / Anti- * The 2-hour anti creasing programme
creasing" LED to prevent laundry from creasing might
flashes. have been activated.
"Final / Anti-
creasing" LED is * Program has come to an end.
on.
* A heat sensor failure has occurred.
The "Drying" LED
Machine ends the programme without
flashes.
heating.
"Filter cleaning"
* Filter might have not been cleaned.
LED flashes.
Also for products equipped with a condenser
* Water may be full.
"Water tank"
* Anti-creasing programme might be
warning LED is on.
running.
"Condenser
* Filter drawer/Condenser might have
cleaning" LED is
not been cleaned.
on.
A
Call an authorized service agent if the problem persists.
Cause
Cover filter and filter drawer might
Explanation / Suggestion
* Clean the cover filter and Filter drawer.
* Clean the cover filter and Filter drawer.
* Do not overload the machine.
* Make sure that the machine is plugged in.
* Make sure that the loading door is
properly closed.
* Make sure that the programme has been
set and it is not in "Pause" mode.
* Deactivate the childproof lock.
* Make sure that the condenser cover and
the red lock is closed securely.
* Make sure that the loading door is
properly closed.
* Press "Start/Pause/Cancel" button to
start the programme.
* Dry only the laundry which is suitable for
drying in your machine after checking the
labels on your clothes.
* Select a programme with suitable low
temperature for the laundry type to dry your
clothes.
* Make sure that the machine is On.
* Call the authorized service to replace the
bulb.
* Turn off the machine and take out the
laundry.
* Turn off the machine and take out the
laundry.
* Turn off the machine and take out the
laundry. Call your authorized service.
* Clean the cover filter.
* Drain the water in the water tank.
* Clean the filters in the condenser/filter
drawer under the kick plate.
22 - EN