Panasonic NN-S215WF Service Manual page 19

5. Open Door E at the opening angle of approximately 10°(Note: The
door cannot be removed if the opening angle is greater than 10°).
6. Remove the door E from its hinges by pushing the door E's
bottom upward and out.
7. Remove door key and door key spring from door E.
8. Replace other components.
NOTE:
Door alignment is crucial. If door is misaligned, apply pressure until
alignment is achieved.
NOTE:
After replacement of the defective component parts of the door,
reassemble, and perform microwave leakage test.
7.7. Turntable motor
1. Remove the motor cover by breaking off at the 4 spots indicated
by arrows with a cutter or the like.
NOTE:
After breaking off the motor cover, make sure that cut-off portions
are properly trimmed off or bent to inside so that no sharp edges
will be exposed to the outside.
2. Disconnect 2 lead wires connected to the turntable motor.
19