Dsp Usage; Rs-232 Control Port - B&K Reference 20 Plus A/V System Controller Owner's Manual

DSP Usage

Allows displaying the current DSP usage in MIPS.
ADVANCED SYSTEM SETUP
1 Zone 1 Setup 'A'
2 Zone 2 Setup 'B'
3 Power On Titles
4 Control Out
5 Security Options
6 DSP Usage
6 DSP Usage

7 RS-232 Control Port

next item
From Remote
­ V
1
(PAUSE) or (STOP)
2 SEL or ENTER
­ V
3
(PAUSE) or (STOP)
RS-232 Control Port
Configure the advanced computer interface control port on your processor. For further information concerning RS-
232 operation, see BKC-DIP for the computer interface protocol, and the AVR202 Plus and Reference 20 Plus
device specific appendix's.
RS-232 port setup -
ADVANCED SYSTEM SETUP
1 Zone 1 Setup 'A'
2 Zone 2 Setup 'B'
3 Power On Titles
4 Control Out
5 Security Options
6 DSP Usage
7 RS-232 Control Port 7 RS-232 Control Port
next item
From Remote
­ V
1
(PAUSE) or (STOP)
2 SEL or ENTER
­ V
3
(PAUSE) or (STOP)
X W
4
(REW) or (FF)
SEL select
MENU setup system
'63 86$*(
From Front Panel
(UP) or (DOWN)
(ENTER)
(UP) or (DOWN)
SEL select
MENU setup system
56 3257
From Front Panel
(UP) or (DOWN)
(ENTER)
(UP) or (DOWN)
VOLUME KNOB
DSP USAGE
1 Utilized DSP 1 Utilized DSP
Processing Power Processing Power
XXX MIPS XXX MIPS
MENU advanced setup
;;; 0,36 )5((
Action
move to DSP Usage
activate DSP USAGE
display currently used DSP MIPS
RS-232 PORT SETUP
1 Port 1 Port
2 Baud Rate
3 Echo
4 Update
5 Receive ID
6 Transmit ID
next item
MENU advanced setup
3257 (1$%/('
Action
move to RS-232 Control Port
activate RS-232 PORT SETUP
move to Port
select Enabled or Disabled
73
Enable Enable
9600
Enable
Enable
0
0
SEL select
13258 11/01