B&K Reference 20 Plus A/V System Controller Owner's Manual page 70

Link Zone 2 (B) input to Zone 1 (A) input selection - Zone 2 (B) input source selection may be linked with Zone
1 (A) source selections. In operation, whenever a source selection is detected (remote, front panel or RS-232) on
Zone 1 (A), source linkage will cause the source to be selected on both zones. Independent source selection is
still available with Zone 2 (B) remote control, but any Zone 1 (A) source selection supersedes the previous Zone 2
(B) selection.
From Remote
­ V
1
(PAUSE) or (STOP)
X W
2
(REW) or (FF)
Link Zone 2 (B) power to Zone 1 (A) power - Zone 2 (B) power On/Off may be linked to Zone 1 (A). In
operation, whenever power is set to On in Zone 1 (A) the power linkage feature will cause power to be set
accordingly on Zone 2 (B). Zone 2 (B) Independent power on/off is still operational with the Zone 2 (B) remote
control, but any Zone 1 (A) power command supersedes the previous Zone 2 (B) power on/off.
From Remote
­ V
1
(PAUSE) or (STOP)
X W
2
(REW) or (FF)
3 MENU
ADVANCED ZONE B SETTINGS
1 Level Control Variable
2 Fixed Level
3 Zone ID
4 V2 Output
5 Link Input to Zone A
5 Link Input to Zone A
6 Link Power to Zone A
next item adjust
MENU advanced setup
=% /,1. 65& 12
From Front Panel
(UP) or (DOWN)
VOLUME KNOB
ADVANCED ZONE B SETTINGS
1 Level Control Variable
2 Fixed Level
3 Zone ID
4 V2 Output
5 Link Input to Zone A
6 Link Power to Zone A 6 Link Power to Zone A
next item adjust
MENU advanced setup
=% /,1. 3:5 12
From Front Panel
(UP) or (DOWN)
VOLUME KNOB
Ø
MENU
67
+15 dB
2
Tape
No
No
No
Action
move to Link Input to Zone A
set to Yes or No
+15 dB
2
Tape
No
No No
Action
move to Link Power to Zone A
set to Yes or No
return to ADVANCED SYSTEM SETUP
13258 11/01