Bosch rexroth HyDrotrAC GFt Operating Instructions Manual page 14

14/64 HyDrotrAC GFt >130 knm | General information concerning damage to property and product damages
CorreCtion Copy 1 |17.10.2019 | onLy For internAL USe
Bosch Rexroth AG, Issue 10.2019, RE 79094
Damage to the planetary gearbox caused by commissioning without or with
insufficient lubricating oil!
When commissioning the planetary gearbox and the integrated static multiple-disk
parking brake without, or with insufficient lubricating oil can damage or even being
completely destroyed!
f When commissioning or recommissioning the machine or a vehicle, fill the
planetary gearbox with the correct quantity of oil.
f Check the oil level thoroughly.
f Pay attention when commissioning the machine or vehicle, that the housing
chamber and the axial-piston motor (if included in the scope of supply)
service lines are filled with hydraulic fluid and remain filled during operation.
f Always replace the disks, springs and sealing elements per axle after any
malfunction, thermal overload and during any repair work on the multiple-disk
parking brake.
Damage to the planetary gearbox caused by commissioning with too much
lubricating oil!
When commissioning the planetary gearbox and the static multiple-disk parking
brake, integrated in the planetary gearbox, with too much lubricating oil, thermal
overloads may occur, causing damage to the gears, seals and bearings as well as
failure of the static multiple-disk parking brake!
f When commissioning or recommissioning the machine or a vehicle, fill the
planetary gearbox with the correct quantity of oil.
f Check the oil level thoroughly.
f Always replace the disks, springs and sealing elements per axle after any
malfunction, thermal overload and during any repair work on the multiple-disk
parking brake.
Damage caused by penetrating liquids, foreign objects and dirty lubricating oil!
Wear and malfunctions caused by impurities!
f Check whether all seals, connections and plug-in connectors have been
correctly installed and are intact.
f When performing any work on the planetary gearbox, please ensure extreme
cleanness to prevent foreign objects, as for example weld spatter or metal
particles, from getting into the planetary gearbox and, therefore, causing wear
and malfunction.
f Only use clean connections.
f Exclusively install clean hydraulic lines.
f No dirt shall penetrate when closing the ports.
NOTE