Toro LT-F3000 Installation Instructions Manual page 2

1
Preparing to Install the Kit
No Parts Required
Washing the Machine
Important:
Before installing this kit, you
must thoroughly clean the machine to avoid
contaminating the hydraulic system—a clean
machine is required.
Wash the machine; refer to washing the machine in
the Operator's Manual for your machine.
Preparing the Machine
1. Park the machine on a level surface.
2. Lower the cutting units.
3. Engage the parking brake.
4. Shut off the engine, remove the key, and wait for
all moving parts to stop.
5. Allow the engine to cool completely.
Removing the Storage
Compartment
Models 31657 and 31659
1. At the left side of the operator's platform, open
the door of the storage compartment
1. Washer
2. Knob
2. Remove the 3 knobs and 3 washers that secure
the storage compartment to the machine, and
remove the compartment
Disconnecting the Battery
1. Loosen the forward nut of the negative
battery-cable terminal
(Figure 1).
1. Nut (negative
battery-cable terminal)
2. Lift the negative battery cable from the battery
post
Note:
it cannot contact the negative battery post.
2
Figure 1
3. Storage compartment
(Figure
(Figure
Figure 2
2. Negative battery post
(Figure 2).
Position the negative-battery cable where
g328513
1).
2).
g344733