Advertisement
PAIRING THE WALL CONTROLL
1.
With the fireplace ON press and hold the ON/OFF button for
about 3 seconds until you hear the buzzer sound twice and the power
indicators begin to flash. (power indicators located top right of viewing
area)
2.
Within 5 seconds on the wall control press the ON/OFF(power)
button repeatedly until the buzzer sounds again and the indicators flash
acknowledging that it has paired. You may also hear another buzzer and
the pair is now completed.
-Pairing must be done within 5 seconds or the fireplace will time out of
pairing mode.
-To clear any paired remotes from the unit locate then press and hold
the reset button for 3 seconds. You should hear a buzzer letting you
know the codes have been cleared so you can now pair a new remote or
wall control. (The reset is located next to the manual controls and can be
pressed with a paper clip.)
www.modernfl ames.com
Please dispose of properly.
©2019
Wireless Wall Mounted Touch Control
V1
MF-PRO-WTC
NEW PART # TH-WTC/LP
Advertisement
Table of Contents
Related Manuals for Modern Flames MF-PRO-WTC
Summary of Contents for Modern Flames MF-PRO-WTC
- Page 1 PAIRING THE WALL CONTROLL Wireless Wall Mounted Touch Control With the fireplace ON press and hold the ON/OFF button for MF-PRO-WTC about 3 seconds until you hear the buzzer sound twice and the power NEW PART # TH-WTC/LP indicators begin to flash. (power indicators located top right of viewing...
- Page 2 Installing Optional Wall Mounted Touch Control This will cycle the machine on and off . Upon cycling 1. Locate 2-gang low voltage bracket within 20 feet of fi replace. Install power on, the machine will return to the settings it Power according to manufacturer’s instructions.
Need help?
Do you have a question about the MF-PRO-WTC and is the answer not in the manual?
Questions and answers