Page 1
Log Installation Step 1 Locate screws holding in the glass and remove...
Page 2
Log Installation Step 2 Carefully remove glass panel by pulling on the tabs located on the left and right side of the firebox lean the glass towards you and lift glass out. Make sure not to drag glass as alignment pegs on bottom may damage module finish.
Page 3
Log Installation Step 3 LOG SET MEDIA LEDs Open the Driftwood Log Set and locate the following: Log set, Smoked Glacier Crystals, LED bulbs Log Configurations: LFV40/15 & LFV2-40/15: (1)-40” Log Set LFV60/15 & LFV2-60/15: (1)-60” Log Set LFV80/15 & LFV2-80/15 : (2)-40” Log Sets (ONE INSTALLED REVERSED) LFV100/15 &...
Page 4
Log Installation Step 4 Locate and remove media tray strips. Both the Clear strip and Colored strip. LFV COLOR STRIP LFV &LFV2 CLEAR STRIP LFV2 COLOR STRIP...
Page 5
Log Installation Step 5 EXAMPLE OF LOCATION OF CONNECTORS FOR LOGS (80” AND ABOVE WILL HAVE TWO CONNECTIONS) *REMOVING MODULE TO LOCATE WIRES WILL MAKE IT EASIER AND SOMETIMES NECESSARY FOR LH CONNECTION*...
Page 6
Log Installation Step 6 After you locating the wires inside the fireplace and the end of the driftwood logs. Plug in wires to each other.
Page 7
Log Installation Step 7 Place the driftwood logs in the center of the firebox so that it sits flush in the designated channel.
Page 8
Log Installation Step 8 Locate your LEDs inside the shipping box. Remove 1 log at a LED EXAMPLE time and note orientation. Install the LEDs in the sockets, simply align the probes from the LEDs to the holes in the socket and insert until fully seated.
Page 9
Log Installation Step 9 Add the smoked glacier crystals around the logs. Then replace glass in the front of the unit where it was first removed from.
Page 10
*CAN BE REVERSED FOR BIGGER UNITS* *CAN BE REVERSED FOR BIGGER UNITS*...
Need help?
Do you have a question about the DWLS-40/15 and is the answer not in the manual?
Questions and answers