Arcam Logo Handbook
Arcam Logo Handbook

Arcam Logo Handbook

Arcam - a & r cambridge sub-bass loudspeaker system user guide

Advertisement

Quick Links

Handbook
Manuel
Handbuch
Handleiding

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Logo and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Arcam Logo

  • Page 1 Handbook Manuel Handbuch Handleiding...
  • Page 2: Safety Guidelines

    (U.S. = ground). The primary method of isolating the Logo speaker unit from the mains supply is to use the switch on the rear of the unit. The Logo speaker unit must be installed in a manner that makes plug disconnection possible.
  • Page 3: Table Of Contents

    LFE (low frequency effects) connection – this is a channeI intended by the recording thank you… ... E-3 engineer to be exclusively reproduced by a subwoofer. Logo’s own volume control permits the level to installation ... E-4 be adjusted independently to achieve a perfect balance in the listening room.
  • Page 4: Installation

    Logo is fitted with a main power switch on the rear panel, above the power inlet: make sure that this is switched on to use Logo. If your Logo is not to be used for a prolonged period, switch the unit off at the main power switch. X-OVER FREQ...
  • Page 5: Speaker Positioning

    Subwoofer The location of Logo will affect the overall sound quality. Placing the subwoofer next to a wall or in a corner will often boost efficiency and give a cleaner low bass sound.
  • Page 6: Stereo System With No Lfe

    IN LFE IN L IN R In such systems, Logo can be set up to work with two crossover frequencies. One frequency is set up for the rear speakers using the surround amplifier crossover, and one frequency for the full range Left and Right speakers, using the Logo crossover.
  • Page 7: Crossover Frequency Setting

    In most surround-sound systems, two crossovers are available: one in the surround-sound decoder and one in the Logo unit. In order to get the optimum sound in a variety of systems, Logo allows these controls to be used independently for systems with ‘Large’ front speakers and an LFE output from the surround-sound decoder.
  • Page 8: Specification

    Note that all specification values are typical, unless otherwise stated. Continual improvement policy Arcam has a policy of continual improvement for its products. This means that designs and specifications are subject to change without notice. One-way speaker, with 10 litres internal volume. The cabinet is solidly constructed from machined MDF with internal bracing.

Table of Contents