Advertisement
STEP A10: Fit contacts to cable conductors
Take the rst contact (4), slide over the conductor and press into slot in the insert (3). The contact (4) will now be retained in the insert (3).
Repeat for all remaining contacts
3
STEP A11: Check alignment of contacts
Firstly con rm all contacts (4) are concentric to the openings in the tip of the insert.
Then ensure the contacts (4) are correctly rotated so that the grub screw is in the centre of the slot.
STEP A12: Apply threadlock and tighten grubscrews
Take the threadlock sachet (9) supplied with the product and tear open. Dispense a drop of threadlock onto the exposed thread of one
contact grub screw. Tighten the grubscrew with a small screwdriver. Recommended torque is 0.75Nm. Wipe away any excess. Repeat for all
contacts.
9
STEP A13: Repeat process for Cable B
The body portion of the product is now terminated onto cable A. Repeat steps A2-A12 for cable B.
Now the body portion is terminated onto both cables and is ready for coupling.
STEP A14: Plug insert into one of the terminated cables
Align the keyways and slide the in-line pin insert (2) over the body portion until the contacts engage.
AI 2046 - Issue D / Page 4 of 7
5
10
4
Cable A
10
15
20
Align Keyways
25
20
30
Cable B
2
Images for illustration purposes only.
Product supplied may di er from that shown.
30
35
40
40
45
Advertisement
