Lcd Messages - Canon MultiPASS C3500 User Manual

LCD Messages

The following messages are displayed in the LCD when the
MultiPASS is performing a function or encounters an error.
The Error Code appears on the Activity Report.
Message
AUTO REDIAL
BUSY/NO SIGNAL
CARTRIDGE JAMMED
10-6 Troubleshooting
Error Code Cause
— The MultiPASS is
waiting to redial the
other party's number
because the line was
busy or the other
party did not answer
when you tried to send
the document.
#005/018 The telephone number
you dialed is busy.
The fax number dialed
was incorrect.
The other party's fax is
not working.
The other party is not
using a G3 machine.
The touch tone/rotary
pulse setting on your
MultiPASS is incorrect.
The receiving fax did
not answer within 35
seconds.
Cartridge holder cannot
move. This is normally
due to a paper jam.
Action
Wait for the MultiPASS
to try redialing. If that
doesn't work, wait until
the MultiPASS starts to
dial the number, then
press to cancel
STOP
redialing. Try to send
the document again at a
later time.
Try sending the
document at a later
time.
Check the fax number
and dial again.
Contact the other party
and have them check
their fax.
Contact the other party
and have them send or
receive the document
using a G3 machine.
Set your MultiPASS
to the setting that
matches your telephone
line (see page 8-4).
Contact the other party
and have them check
their fax. You can try to
send the document
manually. For an over-
seas call, add pauses to
the registered number.
Clear the paper jam or
whatever is obstructing
the cartridge holder
and then press .
STOP
Do not attempt to
move the cartridge
holder manually.
Chapter 10