How To Shut Down - Konica Minolta DRYPRO 832 Manual

Laser imager

Hide thumbs Also See for DRYPRO 832:

Table of Contents

Starting and Shutting Down

3�1�2

How to Shut Down

To shut down DRYPRO 832, perform the following steps.

Check the following points before performing a shutdown opera-

tion�

• The message "Printing" is not shown in the message display window.

If the machine is not shut down after the expiration of three min-

utes or more following a shutdown operation, press and hold the

operation switch again for 10 seconds or longer� The machine will

be shut down� Then, turn OFF the power supply circuit breaker,

and turn it ON again�

After the shutdown operation completes, the deodorant fan contin-

ues to operate for approximately 1 hour�

When performing the shutdown operation, do not switch the power

supply circuit breaker OFF immediately� (To turn the power supply

circuit breaker off, wait approximately 1 hour after completing the

shutdown operation before switching the breaker off.)

Press the operation switch until a beep sounds (about one second)�

The message "Now shutting down Please wait a while" appears in the message

display window and the status LED goes out.

The machine will be shut down in about 10 seconds.

• Leave the power supply circuit breaker ON during normal use.

Table of Contents