Advertisement
Step 7
Once the bearing is in position feed the blank bur up
into the bearing ram on the right side of the press. Slowly
pull down on the handle while holding the turbine in
place until the rear of the spindle meets and is aligned
with the hole in the center of Insert #1. Gently press
bearing down the spindle until it stops at Insert #1. If the
bearing is riding loosely on the spindle use EZ Tight to
hold it on.
Step 9
Locate the front bearing and drop it over the bur so
the silver shielded side faces up and the black side
faces down towards the impeller. Repeat pressing
process until bearing comes to a stop when it reaches
the impeller. If the bearing is riding loosely on the spindle
use EZ Tight to hold it on.
Step 11
!
If the headcap heats up or you feel resistance while
testing remove the turbine and re-inspect the head
with an explorer to make sure no debris was overlooked.
If clean then call for Tech Support.
Step 8
Locate the impeller and repeat process, making sure that
with the bur facing away from you the air would turn the
impeller clockwise or the blades slant left at the 12 o'clock
position. Press impeller until it stops at the bearing.
Step 10
Using an explorer remove the old o-rings from the head
and head cap. Clean the head and head cap with
cleaner and a cotton swab, making sure to remove any
debris. Use your explorer to install the new o-rings into the
head and head cap. Seat the rebuilt turbine into the head
cap and install into head. Tighten cap down completely
and make sure the bur rotates and releases the bur, then
hook up and run.
REPDGM/SM002-Rev A-4/24/2006
Advertisement
