Install The Adapter; Install The Waterway - Jacob Delafon E8014 Instructions Manual

• Install the nipple.
• Thread the nipple into the tee/elbow and hand tighten.
• Measure the distance from the end of the nipple to the surface of the finished wall.
Verify that the distance is at least 3.8 cm and no more than 5.1 cm.
• Remove the nipple.
• Apply thread sealant to the threads of the nipple.
• Reinstall the nipple to the tee/elbow.
• Run water through the system to flush out any dirt or debris.

6. Install the adapter

• Install the adapter to the pipe nipple using a socket wrench with extension, 11 mm
socket, and the provided 11 mm bit.
• Measure the distance from the face of the adapter to the face of the finished wall.
Verify the distance is at least 2.2 cm and no more than 3.5 cm. Make any adjustments
as needed.

7. Install the waterway

18
Adapter
Protector guard
Drain Port
Socket wrench
with bit
2,2 mini
3,5 maxi
Adapter
English
Waterway
Waterway tool