Emc Declaration - Konica Minolta PULSOX-2 Instruction Manual

EMC Declaration

Guidance and manufactureʼs declaration - electromagnetic emissions
The Model PULSOX-2 is intended for use in the electromagnetic environment specified below. The
customer or the user of the Model PULSOX-2 should assure that it is used in such an environment.
Emissions test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC61000-3-2
Voltage fluctuations/
flicker emissions
IEC61000-3-3
Guidance and manufactureʼs declaration - electromagnetic immunity
The Model PULSOX-2 is intended for use in the electromagnetic environment specified below. The
customer or the user of the Model PULSOX-2 should assure that it is used in such an environment.
Immunity test
Electromagnetic
Discharge (ESD)
IEC61000-4-2
Electrical fast
Transient/burst
IEC61000-4-4
Surge
IEC61000-4-5
Voltage dips, short
Interruptions and
Voltage variations
on power supply
Input lines
IEC61000-4-11
Power frequency
(50/60Hz) magnetic
field
IEC61000-4-8
20
Compliance
Group 1
Class B
Not applicable
Not applicable
IEC 60601 Compliance
Test level
6 kV contact 6 kV contact
8 kV air 8 kV
Not applicable
Not applicable
Not applicable
Not applicable
Electriomagnetic environment - guidance
The Model PULSOX-2 uses RF energy only for its
internal function. Therefore its RF emissions are
very low and are not likely to cause any interference
in nearby electromagnetic equipment.
The Model PULSOX-2 is suitable for use in all
establishments, including domestic establishments.
Electromagnetic environment -
level
Floors should be wood, concrete or
ceramic tile, if fllors are covered with
synthetic materisl, the relative humidity
should be at least 30%.
guidance