Use; A - On/Off Key; B - Fan Speed - Olimpia splendid AURA CARE Instructions For Use And Maintenance Manual

e. Correctly position the filter (2) in the appliance.
f. Position the rear panel (1) on the appliance body (6) by inserting the lower hooks (1b) in the specific
seats (6b) first, then press the lever (1a) and push the panel (1) until you hook it (fig.C).
Do not use the appliance without the filter (2) or if the latter is dirty or worn-out
g.
Use the specific handle (8) in order to move the appliance.
h. Insert the plug in the power socket, the appliance switches on the display for a few seconds and emits
a beep.
Before electrically connecting the appliance, make sure the plate data correspond
to those of the electricity distribution network.

3.3 - USE

Each time the keys are pressed, the appliance emits a "beep".

3.3.a - ON/OFF key

By pressing the ON/OFF (T1) key, the appliance switches on and the LED (D3) lights up on the display,
detecting the quantity of impurities in the air (reference value "PM 2.5").
During preheating (approximately 30 seconds), the UV lamp (10) changes colour following this sequence:
Blue -- > Cyan -- > Green -- > Yellow -- > Orange -- > Red -- > Purple -- > Blue -- > ...
After the 30 seconds have passed, the UV lamp (10) changes to a single colour depending on the de-
tected air quality.
Ex. Blue lamp: good air quality, the appliance works in low mode.
Yellow lamp: medium air quality, the appliance works in medium mode.
Red lamp: low air quality, the appliance works in high mode.
To switch off the appliance, press the key ON/OFF (T1) again.

3.3.b - Fan speed

By pressing the mode key (T2), 3 different modes can be selected:
- "Auto" (Led D1)
adjusts fan speed based on air quality.
- "Turbo" (Led D2)
the fan works at maximum speed.
- "Sleep" (Led D4)
once this mode is selected, after approximately 5 seconds the display switches off and the fan speed
is automatically set to the minimum.
Press the key (T2) again or any other key to deactivate the mode.
EN - 9
AURA CARE