Advertisement
3.3 Connect to the gateway's network
1. Set your gateway to permit joining.
2. The LED panel light connected to the LED Lighting Driver will start
flashing after installation indicating it is ready to join the gateway's network.
3. The LED Lighting Driver will join the gateway automatically and the LED
panel light will turn steady when successfully joined.
4. Now you can find the LED Lighting Driver under the Automation interface
of the mobile app.
Note: If the LED Lighting Driver fails to join the gateway's network within
one minute, simply reset the LED Lighting Driver and retry.
Reset. Turn ON, and turn OFF. Repeat this action three times using a
physically connected power supply. The LED panel light will start flashing
when reset successfully. Try three more times if this fails.
4
Advertisement
