Panasonic WV-CW7S Operating Instructions Manual page 3

Dome cover
Hide thumbs Also See for WV-CW7S:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Step 3
Replace the dome cover
q
Attach the waterproof rubber provided with
the new dome cover to the enclosure.
Make sure that the waterproof rubber is
attached without distortion or deformation.
Do not use the waterproof rubber removed
from the enclosure. Use the new water-
proof rubber provided with the new dome
cover.
w
Remove the protection film covering out-
side the new dome cover.
Keep the removed protection film until
using it upon the installation.
(Handle the new dome cover with care not
to scratch inside and outside.)
e
Fit the new dome cover, the
sheet and the dome cover holding plate
together while aligning the holes on them
to the 2 protrusions inside the enclosure,
and then fix them using the 2 dome cover
fixing screws (without washers).
(Recommended tightening torque:
0.78 N·m {0.58 lbf·ft})
r
Attach the protection film removed in step
3 - w back to the outside the dome cover.
t
When fixing the third dome cover fixing
screw (with washer), fix the installation
auxiliary wire together.
When fixing with the screw, make sure that
the flat face of the fixing terminal is the sur-
face side of the dome cover holding plate.
Make also sure that the fixing terminal is
not on the projection of the dome cover
holding plate. (Refer to the diagram below.)
(Recommended tightening torque:
0.78 N·m {0.58 lbf·ft})
Step 4
Fit the enclosure back to the camera body
Fix the enclosure onto the camera body using
the 4 enclosure fixing screws.
The recommended tightening torque for the
enclosure fixing screws is 0.78 N·m {0.58 lbf·ft}.
Refer to the Installation Guide of the camera
for the subsequent procedures including the
installation of the camera body.
IMPORTANT:
light-blocking
Defocus may be caused by the reinstalled
enclosure. After installing the enclosure,
activate the auto focus function from the
setup menu.
Remove the protection film covering the
outside of the dome cover after completing
the installation.
Wipe out with a soft cloth when cleaning
adhesion of dirt such as a fingerprint.
3

Advertisement

Table of Contents
loading

Table of Contents