Factory Adjustment - Philips 150B3M Service Manual

22
150B3B LCD
Go to cover page
Factory Mode Adjustment
Entering Factory Adjustment Menu
Push & buttons then power on the monitor, release them
after picture display normally. Press
menu of factory mode as shown below.
HUDSON 150P V1.56D 01-03-09
Use button to select factory adjustment indication (for example: ,
HUDSON 150P V1.56D 01-03-09which is the entrance of the factory
adjustment menu, press button to access it. The window shows
as below.
Use or buttons to select SUB-CON, 9300K R G B,..etc.
Use or buttons to decrease/increase the value of each item
: adjust Sub-brightness & Sub-contrast automatically.
AUTO
Contrast adjustment (Sub-Contrast). Use this menu item to
adjust the contrast gain of pre-amp ranges from 0 to 255.
9 3 0 0 K R G B
6 5 0 0 K R G B
Color temperature gain adjustment. Use these menu items to
adjust the RGB gains of pre-amp for different color
temperatures, ranges from 0 to 255.
OFFSET R G B
Sub-Brightness adjustment. Use this menu item to adjust
the brightness level (DC-level) of pre-amp range from 0 to
255.

Factory Adjustment

button to bring up OSD
PRESET VIDEO RESOLUTION
(PS: The Offset R G B function can be used on reduce or eliminate
snowy noise on the background when the resolution of video signal is
1024 X 768 vertical 60Hz. Slightly increase or decrease the value
until snowy noise completely disappear.)
Monitor front board